|Signal Phasing Diagram (assuming a median)|
Incorporation of bikes, trams are something the Dutch have done because of the challenges or complexities these modes have presented as a part of large projects. The signal phasing numbering scheme is set up in VRIGen and it is used throughout the country to standardize and allow them to deal with all (most) possible options. It seems they have used every number from 1 to 100 to make the various modes work together under a standard umbrella.
|Signal Phasing assuming Transit in the Median|
Note: transit can turn from each direction and bikes wither would
be handled different than shown.
How is this different than the U.S.?
In the U.S., we have 8 vehicle phases, multiple overlaps, and pedestrian movements tied to the parallel vehicle and LRT is handled as a preempt as opposed to another movement. The standard signal controller is not prepared for light rail or bus crossings in both directions (east-west & north-south) running on the median. The Dutch also assume the special considerations of the use of multiple numbers to allow 2 stage crossings as a part of the bikes & peds because of their slower speeds. This also allows "following" phases to occur for vehicles so progression can be achieved through an interchange or a set of two signals, like you might have at a diamond interchange.
What common guidelines do they apply that the U.S. should adopt?
The maximum cycle length is a good place to start. 120 seconds is an eternity for peds and bikes and that value and higher is to going to result in poor compliance and high delays for public transport
Another common approach is to use snappy detector timing. The use of 1.5 seconds of extension from the upstream (advance) detector is limited to the detector placed 30 meters from the stop bar with a detector that is 12m long. They use a 2.5 gap on the stop bar detector with a 2.5 second extensin with presence mode enabled, meaning that when a vehicle is present on the detector it continues to ask for more green.
We discussed the use of leading pedestrian (or bike) intervals (LBI or LPI) and it was surprising to hear they use 2 secs. They use LBIs when there is no right turn lane exclusive for controlling the traffic separately in two separate "streams" which is much preferred in the Netherlands for safe operations that remain efficient. Notice I stated safety was first, Theo indicated that more than half of all signals are there for insuring safe conditions for all users. Our MUTCD is a far cry from that without the proper use of engineering judgement and a strong protection of future multimodal traffic growth.
What are the downsides of this approach?
There were a few things I would like to discuss more with a practicing Dutch traffic engineer. The common practice is to separate out the right turns. This clearly results in a different set of conflicts as shown here:
The bike movement is labelled 21 (on the left in the red brick area) and the right turn is labelled 6 in the graphic (to the left of the car you can see the right turn arrow).